LIVARNO LUX 304540 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 16

Now place the spotlight 3 towards the mounting plate 6 .
Ensure that the ball joint of the mounting plate 6 is correctly
inserted into the slot 9 of the spotlight 3 . Then, close the ball
joint cover 7 by tightening the screws clockwise (Fig. B).
Set the ON/OFF switch 2 on the spotlight 3 to the "ON"
position (Fig. A).
The rechargeable batteries 11 will now charge when there is
sufficient solar radiation.
For HG04465B:
Remove the mounting plate 6 from the spotlight 3 by loosening
the screws of the ball joint cover 7 (Fig. B).
Use the slotted holes of the mounting plate 6 intended for the
screws 8 to mark the drill holes.
Now drill the fixing holes (Ø 8 mm, depth approx. 40 mm).
Before drilling the fixing holes, ensure there are no gas, water or
electrical lines that could be drilled into or damaged in the area
where you will be drilling.
Insert the dowels 5 into the drill holes (Fig. B).
Attach the mounting plate 6 using the screws 8 provided
(Fig. B).
Now place the spotlight 3 towards the mounting plate 6 .
Ensure that the ball joint of the mounting plate 6 is correctly
inserted into the slot 9 of the spotlight 3 . Then, close the ball
joint cover 7 by tighten the screws clockwise (Fig. B).
16 GB/IE/NI