LIVARNO LUX 304540 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 17

Now use the slots in the mounting bracket 14 intended for
the screws 16 to mark the drill holes (Ø 8 mm, depth approx.
40 mm).
Ensure that you can connect the spotlight 3 using the connection
cable 17 to the solar panel 1 .
Now drill the fixing holes. Before drilling the fixing holes, ensure
there are no gas, water or electrical lines that could be drilled
into or damaged in the area where you will be drilling.
Insert the dowels 15 into the drill holes (Fig. C).
Attach the mounting bracket 14 using the screws 16 .
Place the solar panel 1 into the mounting bracket 14 (Fig. C).
Ensure that the solar panel 1 is orientated towards the sun.
Insert the plug 18 into the socket 19 (Fig. D).
Set the ON/OFF switch 2 on the spotlight 3 to the "ON"
position (Fig. A).
The rechargeable batteries 11 will now charge when there is
sufficient solar radiation.
When selecting the mounting location for the solar panel 1 , pay
attention to the following:
The solar panel 1 needs to be as directly exposed to sunlight as
possible. Even partial shading of the solar panel 1 during the day
can have a significant influence on charging.
GB/IE/NI 17