Publicité
Les langues disponibles
Les langues disponibles
V 2.0
OPERATION
1. Check the cutting wheel for wear. Replace if necessary.
2. Set the air pressure regulator on the air compressor to 90 PSI.
3. Connect the tool to the air hose.
4. Place the tool over the workpiece and squeeze the throttle lever.
5. Allow the tool to run idle for a few seconds before touching it to the workpiece.
6. Do not put excessive pressure on the tool. This will cause the cutting wheel to lose speed and reduce
efficiency. It will also place additional strain on the motor.
7. Do not cover the exhaust ports while the tool is in use. This may cause damage to the motor and reduce the
efficiency of the tool.
8. When cutting, avoid tilting the tool. Do not change the angle of the tool. during the cut.
9. When you are finished using the tool, gently release pressure from the throttle lever.
10. The cutting wheel will continue to spin. Do not put the tool down until it has completely stopped moving.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to control and will prevent
unnecessary problems.
2. Keep the tool handles clean, dry and free from oil/grease at all times.
3. Follow instructions for lubricating and changing accessories.
4. Inspect the tool fittings periodically. Have damaged or worn components repaired or replaced by an
authorized technician.
5. Inspect the tool fittings, alignment and hoses and components periodically. Have damaged or worn
components repaired or replaced by an authorized technician.
6. Sharp tools are safer than dull tools. Applying excessive force while using a dull tool can lead to slips and
cause damage to your workpiece or personal injury.
7. Maintain the tool's label and name plate. These carry important information. If unreadable or missing,
contact Princess Auto Ltd. for replacements.
CAUTION! Only qualified service personnel should repair the tool.
LUBRICATION
Only use the lubricants supplied with the tool or specified by the manufacturer. Other lubricants may not be suitable
and may damage the tool or cause a malfunction during use.
CAUTION! NEVER use a penetrating oil to lubricate the tool. Penetrating oil may act as a solvent that will break
down the grease and cause the tool to seize up.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the steel parts to avoid rust. Remove the
lubricant before using the tool again.
12
3 in. Air Cut Off Tool
For technical questions call: 1-800-665-8685
8344046
Publicité
