Publicité
Les langues disponibles
Les langues disponibles
8344046
UNPACKING
1. Carefully remove the parts and accessories from the box. Retain packaging material until you have carefully
inspected and satisfactorily installed or operated the tool.
2. Make sure that all items in the parts list are included.
3. Inspect the parts carefully to make sure the tools and accessories were not damaged while shipping.
WARNING! Do not operate the tool if any part is missing. Replace the missing part before operating. Failure to
do so could result in a malfunction and serious personal injury.
PARTS IDENTIFICATION
Contents:
•
3 in. Air Cut-off Tool
•
Spanner wrench
•
Hex wrench
CUTTING WHEEL INSTALLATION
CAUTION! Any vibrating wheels should be replaced immediately.
NOTE: When this manual refers to a part number, it refers to the included parts list.
1. Using the spanner wrench (no. 33), hold the spindle (no. 25) in place so that the spindle will not move.
2. Using the Allen wrench (no. 32), remove the hex screw (no.31) and the washer (no. 30).
3. Remove and replace the cutting wheel.
4. Replace the hex screw and the washer.
5. Allow the tool to run idle for a few seconds with the cutting wheel correctly assembled.
For technical questions call: 1-800-665-8685
3 in. Air Cut Off Tool
V 2.0
11
Publicité
