Publicité
Les langues disponibles
Les langues disponibles
8344046
AIR COMPRESSOR
Ensure the compressor used with the tool can supply the required Cubic Feet per Minute at the required PSI
(see Specifications).
1. Use proper size and type of air pressure line and fittings.
2. Use only clean, dry, regulated compressed air at the rated range as marked on the tool.
CAUTION! Do not use an air source other than an air compressor to
power this tool.
3. Always use an air regulator, an in-line filter and a moisture trap
in your compressed air system. These accessories will increase
the tool's life and keeps the tool in good working condition. See
the diagram for recommended components of an air line.
4. Avoid using an air hose that is too long. The longer the hose, the
lower the pressure that reaches the tool, possibly causing it to
cease functioning. As well, a longer hose can become a
tripping hazard.
5. Air tool CFM consumption ratings are based upon a 25% duty
cycle. If you require continuous duty, a larger compressor
is required.
AIR SOURCE INSTALLATION
WARNING! Never use pure oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for a
tool. Such gases are capable of causing an explosion and serious injury to persons.
1. Set the air pressure regulator on the air compressor to the recommended PSI level (see Specifications). Do
not exceed the tool recommended air pressure. Excess pressure could result in damage to the tool, to your
workpiece or serious injury.
2. Prepare a standard 1/4 in. air connector for use with your tool. Wrap the threaded portion of the air
connector with thread seal tape. Wrap in a clockwise direction so it will not unravel when attaching to a quick
connector. Attach it to the tool air inlet and tighten.
3. Attach a standard quick connector to the air source's hose. Attach the air hose to the tool's air connector.
4. Check the air line and its connections for air leaks. Do not use the tool until you have repaired all air leaks.
For technical questions call: 1-800-665-8685
3 in. Air Cut Off Tool
V 2.0
9
Publicité
