Power Fist 8344046 Manuel D'utilisateur page 7

8344046
CUT OFF TOOL SPECIFIC WARNING
WARNING! Immediately switch off the tool if any of the following occurs:
• The switch or trigger is broken.
• The tool will not shut off on it own. Disconnect from air source.
• The user sees or smells smoke.
• The user smells the odor of scorched insulation.
• The cut off wheel is wobbling or loose.
1. Only use cut off wheels that are approved for a speed of 18,000 RPM or greater (see specifications).
2. Only use cut off wheels with the correct arbor size for the spindle of the cut off wheel (see specifications).
3. Ensure the cutting wheel has a clean cutting edge. Check the cutting wheel for wear or chipping and replace
if necessary.
4. Never install more than one disk at a time.
5. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact
hidden wiring or its own power supply cord. Contact with a live wire will electrify exposed metal parts of the
tool and shock the operator.
6. Before using the tool on the workpiece, run the tool at the highest speed, without a load, for at least 30
seconds in a safe position. Stop immediately if there is any vibration or wobbling that could indicate poor
installation or a poorly balanced cut off wheel. Check the tool to determine the cause.
7. Do not allow the motor to overload or overheat. Take breaks to rest the tool.
8. When the machine is in operation, keep hands away from the cutting area.
9. Do not subject the cut off wheel to any lateral pressure as it may damage the tool or cause it to kickback.
10. Do not use the tool on any materials containing asbestos.
11. Do not place the tool down after use until the cut off wheel has come to a complete stop. The cut off wheel
will not stop immediately when the machine is turned off.
12. Do not touch the cut off wheel or the workpiece surface cut with this tool. They may be hot and could inflict
a burn injury.
For technical questions call: 1-800-665-8685
3 in. Air Cut Off Tool V 2.0
7