Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
coolers. Do not use unit to lift other attached equipment.
The compressor should be installed on a level floor or foundation of sufficient strength and rigidity to support it
without vibrating. It is recommended to use shims under the mounting feet to level the compressor, to prevent
"rocking in" and excessive vibration. To reduce vibration, isolator pads, Model 4C975, are recommended. When
isolators are used, install a flexible coupling between the tank and any pipe permanently attached to the tank.
floor. This may cause eventual failure.
Install and operate unit at least 24 in. from any obstructions in a clean, well ventilated area. This will ensure
an unobstructed flow of air to cool compressor and allow adequate space for maintenance. Never operate
compressor in a small, closed room. Vent the engine exhaust to outside.
When using isolator pads, do not draw bolts tight. Allow the pads
to absorb vibrations. When isolators are used, a flexible hose or
coupling should be installed between the tank and service piping.
possible bursting.
Installing A Shut-Off Valve
A shut-off valve should be installed on the discharge port of the tank
to control the air flow out of the tank. The valve should be located
between the tank and the piping system.
tank. Personal injury and/or equipment damage may occur.
Never use reducers in discharge piping.
Disconnect and release all pressure from the system before attempting to install,
service, relocate or perform any maintenance.
Do not lift or move unit without appropriately rated equipment. Be sure the unit is
securely attached to lifting device used. Do not lift unit by holding onto tubes or
Never use the wood shipping skids for mounting the compressor.
When permanently installing compressor for stationary use or mobile use such as
a truck, avoid overstressing a mounting foot by "pulling the foot down in" to the
Do not locate the compressor air inlet near steam, paint spray, sandblast areas or
any other source of contamination.
Failure to properly install the tank can
lead to cracks at the welded joints and
Never install a shut-off valve
between the compressor pump and the
Figure 3 - Isolator Pad
Figure 4 - Shut-off Valve
7
Publicité
