Franke FSM 97 P XS Manuel De L'utilisateur page 6

FIRST TIME USE
1.
SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: Press
icon and the two digits for the hour start flashing on
the display�
Use or to set the hour and press
The two digits for the minutes will start flashing� Use
or to set the minutes and press
Please note: When the
following lengthy power outages, you will need to reset the
time.
2.
SET THE POWER CONSUMPTION
The oven is programmed to work at a power of less
than 2�9 kW ("Lo"): To operate the oven at a power that
is compatible with a domestic power supply of greater
than 3 kW ("Hi"), you will need to change the settings�
To go to the change menu, turn the selection knob to
, then turn it back to
Press and hold and
afterwards�
DAILY USE
1.
SELECT A FUNCTION
To select a function, turn the selection knob to the
symbol for the function you require: the display will
light up and an audible signal will sound�
2.
ACTIVATE A FUNCTION
MANUAL
To start the function you have selected, turn the
thermostat knob to set the temperature you require�
Please note: During cooking you can change the function
by turning the selection knob or adjust the temperature by
turning the thermostat knob.
The function will only start if the thermostat knob is on 0 °C.
You can set the cooking time, cooking end time (only if you
set a cooking time) and a timer.
6
until the
to confirm�
to confirm�
icon is flashing, for example
�
for five seconds immediately
Use or to change the setting, then press and
hold for at least two seconds to confirm�
3.
HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: This is completely
normal�
Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours�
Remove any protective cardboard or transparent film
from the oven and remove any accessories from inside
it�
Heat the oven to 250 ° C for about one hour,
preferably using the "Maxi Cooking" function� The
oven must be empty during this time�
Follow the instructions for setting the function
correctly�
Please note: It is advisable to air the room after using the
appliance for the first time.
AUTOMATIC
To start the automatic function you have selected
("Bread" or "Dessert"), keep the thermostat knob at the
position for automatic functions (0)�
To finish cooking, turn the selection knob to position 0�
Please note: You can set the cooking end time and timer.
RISING
To start the "Rising" function, turn the thermostat
knob to the relevant symbol; if the oven is set to a
different temperature, the function will not start�
Please note: You can set the cooking time, cooking end time
(only if you set a cooking time) and a timer.
3.
PREHEATING AND RESIDUAL HEAT
Once the function starts, an audible signal and a
flashing icon on the display indicate that the
preheating phase is active� When the set temperature
has been reached, the icon becomes fixed and a new
audible signal will sound to indicate that the food can
be placed inside and cooking can proceed�