Power Fist 8843732 Mode D'emploi page 7

V1.0
Contents: •
•
IDENTIFICATION KEY
A Nosepiece
B Outer Sleeve
C Hanging Hook
D Safety Cap
E Trigger
F Air Filter
G Air Cylinder
H 1/4 in. Air Inlet
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
INSTALL AIR CONNECTOR
Prepare a standard 1/4 in. NPT male air connector (sold separately) for use
with your tool.
1. Wrap the external threads of the male connector with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the connector into the tool's air inlet (D) and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected directly
to the air tool. To overcome this, connect a leader hose to the tool. A quick
coupler may then be used to connect the leader hose to the air line hose.
Visit www.princessauto.com for more information
1/4 in. Air Riveter
Air Riveter • Wrench x 2
Jaw • O-ring x 4 (#B02 and B12)
• Nosepiece x 4
8843732
Fig. 1
7