Publicité
Les langues disponibles
Les langues disponibles
8843732
NOSEPIECES
1.
Remove the base cover (#34) from the air cylinder (Fig. 2)
2.
Select the appropriate sized nosepiece (A) for your task from the four
nosepieces stored in the bottom (Fig. 3).
3.
Fit the wrench's center hex (#C02) over the nosepiece and twist
counterclockwise to free it (Fig. 3)
4.
Insert the nosepiece into the jaws (#4) within the outer sleeve (B) and twist
clockwise (view from front) to lock it in place (Fig. 4). Remove the wrench.
.
OPERATION
WARNING! Always fit the safety cap (#15) to the rear of the air riveter before
use to prevent a penetrating injury from an ejected rivet mandrel.
CAUTION! Keep fingers away from the trigger while inserting the rivet into
the air riveter. Accidental activation may cause a cut or pinching injury.
One or more holes of the same diameter as the rivet must be drilled into the
workpiece before installing the rivets.
1.
Check the hydraulic oil level before each use (See Adding Hydraulic Oil).
2.
Select the correct nosepiece based on the rivet diameter and install per
Nosepieces section.
3.
Attached the air riveter to the air source and start the compressor.
4.
Push the rivet mandrel (stem) through the nosepiece until the rivet
head touches the nosepiece.
5.
Insert the mandrel head and rivet pin into the pre-drilled hole. Push the
nosepiece against the workpiece.
6.
Squeeze the trigger. The mandrel head will compress the rivet pin
while the mandrel is pulled through the air riveter. The force will snap
8
1/4 in. Air Riveter
Fig. 2
Fig. 3
For technical questions call 1-800-665-8685
V1.0
Fig. 4
Publicité
