Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.1
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts List.
INSTALLING AIR QUICK COUPLER
Prepare a standard 1/4 in. NPT male air quick coupler for use with your tool.
1.
Wrap the external threads of the male quick coupler with sealant tape.
a.
Wrap the tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the quick coupler into the tool's air inlet and tighten with a wrench
until snug.
3.
Run compressor at a low volume and check the connection for air leaks.
Do not use the tool until all air leaks are repaired or the faulty component
is replaced.
NOSE PIECES
1.
Select the appropriate sized nose piece (#1A to 1D) for your task.
IMPORTANT! There are four different sizes of nosepieces that come with the
air hydraulic riveter.
2.
Remove the nosepiece (#1A to 1D) by using the wrench (#51) to remove
the outer cylinder (#2).
3.
Insert the selected nosepiece into the outer cylinder (#2) and reattach the outer
cylinder (#2) to the housing (#15), securing tightly with the wrench (#51).
4.
The hanging ring and pin cap are optional. The riveter can be used without
them. Place the housing cap o-ring (#6) and hanging clip (#7) outside of
housing cap (#8) then turn and lock pin cap nut (#10) with pin cap (#9) put
inside on housing cap (#8). Hanging ring position can be adjusted before
pin cap nut is locked.
Visit www.princessauto.com for more information
1/4 in. Air Hydraulic Riveter
8549776
7
Publicité
Table des Matières
