Sigma RC 1209 Mode D'emploi page 65

7 TRAINING mODE
7.9 TRAINING VALUES AFTER THE TRAINING
Prerequisite: You are in the training mode.
After training, you can view the measured values in the training mode
in peace. With the SET, PULSE (-) and SPEED (+) buttons you can scroll
between each values. In addition to the current training values, the
running computer also shows summed values such as:
Total running time
k
Total distance
k
Total calories
k
Note: Total values are available only when the stopwatch is stopped.
7.10 RESETTING THE TRAINING VALUES
Before you begin a new training, you should set the training values to
zero. Otherwise, the running computer counts the values further.
The summed total values for distance, time and calories remain saved.
Prerequisite: You are in the training mode.
Press and hold the START/STOP button. The display
flashes twice and all values are reset. Then you see
the training mode again.
65