Britax Pavilion 65-G3 Guide D'utilisation page 22

Care and Maintenance
Replacing the HUGS™ with SafeCell Technology
WARNING!
• HUGS chest pads must be used when the child seat is installed
in forward-facing mode.
• HUGS chest pads MUST be removed when a snug
harness cannot be achieved in rear facing for small infants
(approximately 3 months old or younger).
Loosen the harness.
1
a Lift the harness adjuster lever
located under the cover flap
b Grasp the chest clip and pull
outward
* Connect the chest clip for easier
adjustment.
Open the chest clip.
2
a Press tabs
b Pull apart
From the back of the seat,
3
unhook the harness straps
from the yoke.
Pull the harness straps
4
through the harness slots to
the front of the seat.
Remove the chest clip and the
5
comfort pads.
Connect the HUGS strap
6
to one HUGS chest pad by
routing the retainer through
the slot at the top of the HUGS
chest pad and then through
the slot at the bottom ensuring
that it is properly seated on
the back.
40
®
1b
1a
Route the HUGS strap through
7
the harness slot to the back of
the seat on one side.
From the back of the seat
8
hook the HUGS strap onto the
clip and route the rest of the
strap through the opposite
harness slot to the front of the
seat.
Connect the HUGS strap to
9
the second HUGS chest pad.
* Ensure the HUGS strap is not
twisted before continuing.
Route the harness straps
10
through the HUGS chest pads
and chest clip.
Route the harness straps
11
through the harness slots to
the back of the seat.
* Ensure that the harness
straps and HUGS strap are
not twisted and that the
HUGS strap lies flat below the
harness straps.
Nest the end of the right
12
harness strap into the left.
Hook the harness straps onto
13
the yoke. Ensure that the
harness straps are not twisted
and that the ends of the
harness straps are securely
attached to the yoke.
Care and Maintenance
41