Britax Pavilion 65-G3 Guide D'utilisation page 21

Siège auto bébé
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Care and Maintenance
Removing the HUGS™ with SafeCell Technology
WARNING!
• HUGS chest pads must be used when the child seat is installed
in forward-facing mode.
• HUGS chest pads MUST be removed when a snug
harness cannot be achieved in rear facing for small infants
(approximately 3 months old or younger).
Loosen the harness.
1
a Lift the harness adjuster lever
located under the cover flap
b Grasp the chest clip and pull
outward
* Connect the chest clip for easier
adjustment.
Open the chest clip.
2
a Press tabs
b Pull apart
From the back of the HUGS
3
chest pad, angle the strap
retainer and route it through
the slot in the HUGS chest
pad and out through the top to
remove the HUGS strap.
Pull the HUGS strap out
4
through the harness slot to the
back of the seat and unhook
it from the HUGS clip on the
back of the seat.
Pull the HUGS strap through
5
the opposite harness slot to
the front of the seat.
38
®
1b
1a
From the back of the seat,
6
unhook the harness straps
from the yoke.
Pull the harness straps
7
through the harness slots to
the front of the seat.
Slide the harness straps out of
8
the HUGS chest pads and the
chest clip to remove.
Reroute the harness straps
9
through the chest clip only,
ensuring that the chest clip is
in the correct orientation and
the harness straps are not
twisted.
Route the harness straps
10
through the seat to the back.
Ensure that the harness straps
pass through the harness
adjuster.
Nest the end of the right
11
harness strap into the left.
Hook the harness straps onto
12
the yoke. Ensure that the
harness straps are not twisted
and that the ends of the
harness straps are securely
attached to the yoke.
IMPORTANT:
• Store the HUGS chest pads and HUGS strap in a safe location
when not in use.
Care and Maintenance
39

Publicité

Chapitres

Table des Matières
loading

Table des Matières