BONFIGLIOLI ACTIVE ACT201 Mode D'emploi page 93

7.2 Status messages during commissioning (SS...)
The following status messages are possible during Setup:
Status message
SS000 OK
SS001 PC Phase 1
SS002 PC Phase 2
SS004 Parameter
identification
SS010 Setup already
active
SS031 Error – check
P. 259
SS032 Warning Phase
Asymmetry
SS099 Setup not
carried out yet.
7.3 Warning and error messages during
commissioning (SA.../SF...)
Warning messages during guided commissioning
Code Meaning / Measure
SA000 No warning message present.
Error messages during guided commissioning
SF000 No Error
For more information about warning and error messages refer to
the applicable operating instructions document.
12/20
Auto set-up routine has been carried out.
The plausibility check (PC) of the motor data is active.
The calculation of dependent parameters is active.
The rated motor values are checked by the parameter
identification feature.
The setup routine via the control panel is being
carried out.
Error during the auto set-up routine. Check value of
259.
Current Error
The parameter identification feature diagnosed an
unbalance during the measurements in the three
motor phases.
Self-setup has not yet been carried out.
Quick Start Guide ACT
Meaning
GB
91