Electrolux WTGL3VI300 Notice D'utilisation page 98

34 www.electrolux.com
Now, you can set a new washing
programme.
10.11 Opening the door -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator
1. Touch the Start/Pause
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
Close the door and touch the Start/
Pause
The programme or the delay start
continues.
10.12 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
The indicator of the Start/Pause
button goes off.
The door unlocks and the indicator
goes off.
1. Press button On/Off
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
button.
button.
to deactivate
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
10.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The time area shows
display shows the door locked
.
• The indicator of the Start/Pause
button starts flashing.
• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin
button to decrease the spin speed
proposed by the appliance.
2. Press the Start/Pause
appliance drains the water and spins.
The option indicator Rinse Hold
disappears.
If you have selected No Spin
only drain the water.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off
seconds to deactivate the appliance.
10.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is
running.
Press the button On/Off
the appliance again.
• 5 minutes after the end of the washing
programme.
and the
button: the
, the appliance will
button for a few
to activate
.