Daily Use - Drying Only - Electrolux WTGL3VI300 Notice D'utilisation

36 www.electrolux.com
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load
size.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button Start/Pause
the programme. The ProSense
estimation starts.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.
11.3 Washing and Timed
Drying
1. Tap on the Time Dry
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator
the indicator
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start/Pause
start the programme. The ProSense
estimation starts.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.

12. DAILY USE - DRYING ONLY

WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 Preparation to drying
1. Press the On/Off button
seconds to activate the appliance.
to start
button
goes off and
comes on.
button to
for some
11.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display
• The indicator of the Start/Pause
button goes off. The door locked
goes off.
The appliance continues to operate
with the anti-crease phase for
approximately 30 minutes or more if
Anti-crease option was set.
The anti-crease phase reduces
creasing.
You can remove the laundry before
the anti-crease phase is completed.
We recommend, for better results,
that you remove the laundry when the
phase is almost completed or
completed. The indicator
lit.
• Press the On/Off button
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to
dry. The appliance defaults to the
washing only mode and the indicator
of the Mode - Wash button is on.
4. Tap on the Mode - Dry button and
then on the Mode - Wash button to
perform drying only. The indicator of
Mode - Dry button illuminates and the
indicator of Mode - Wash button goes
comes on.
remains
for some