Preparing Electrical Connections - Aprimatic ONDA 500 Notice D'installation Mécanique, D'utilisation Et D'entretien

3.

PREPARING ELECTRICAL CONNECTIONS

!
Warning
The system must only be installed by skilled personnel
qualifi ed in compliance with the regulations of the country
of installation (CEI 64 - 8 / EN 60335-1... standards).
The metallic components of the structure (i.e. the gate and
pillars) must have an earth connection.
• Prepare the electrical connection of the controller and
safety devices in accordance with the lay-out in fi g.7.
Please heed the warnings provided in this manual and
comply with the instructions attached to the installed
components. Prepare the cableways (external or buried)
up to where the devices will be installed.
• The cableway joints to the box should be sealed to
prevent the entry of dampness, insects or small animals.
V AC - Cable 3x1,5mm
• POWER SUPPLY: 230
section); the cable cross-section should be calculated in
accordance with the length of the line.
If it is necessary to use automation power supply cable
sheathing, apply this sheathing before connecting the cable
itself to the derivation boxes.
IMPORTANT! Always install, upstream of the line, a mains
switch which guarantees a multipole cut-off with minimum
contact opening of 3 mm (connect it to a 6 A differential
overload switch with sensitivity of 30 mA).
• The command and control accessory devices and the
emergency button should be placed within sight of the
automation, away from moving parts and at a minimum
height of 1.5 m from the ground.
8 8 8 8
1
a
control unit .............................................. a 2 x 1,5 mm
1
operator .................................................. b 3 x 1,5 mm
2
antenna 433.92 MHz .............................. c supplied cable
3
flashing light ........................................... d 2 x 1 mm
4
photocell pair .......................................... e transmitter 2 x 0,75 mm
5
key switch............................................... f 3 x 0,75 mm
6
OPTIONAL control devices .................... g 3 x 0,75 mm
7
Proximity reader* , Magnetic card reader* , Electronic keypad*
remote control
8
ONDA 500/501/800/801
2
(minimum
5
2
!
e
b
230 VAC
6A
lc= 30mA
!
The electric connections must be made
by qualifi ed personnel and with the control
unit disconnected from the mains.
Carry out the connections following the control unit
instructions.
Use the press-cables PG21 type.
Seats of the control
unit inside the operator.
The 3 fi xing screws are
supplied with the control
unit.
3
4
+ earth
2
+ earth
2
2
2
2
2
* optional accessory (see the sales catalogue)
- 17 -
SLIDING GATES
A
If you want to install
ex-novo the control
unit inside the operator,
unplug and disconnect
the terminalboards A.
Cable lug to be used for
gearmotor earthing
Cable fi ttings
5
7
c
6
d
f
ti
f
e
8
; receiver 4 x 0,75 mm
2
Fig.6
A
Fig.7