Nice Maestro300 Instructions Et Avertissements Pour L'installation Et L'utilisation page 52

Led P1 [D]
Off *
On
Series of quick flashes, from
1 to 4
5 quick flashes
1 slow flash
3 slow flashes
5 slow flashes
Led P2 [E]
Off *
On
1 flash per second
2 flashes per second
Led P3 [F]
Off *
On
1 flash per second
2 flashes per second
* or it could be in "Standby" mode
29
24 – English
Status
All OK
Memorisation in Mode 1
Memorisation in Mode 2
Cancellation OK
Wrong command
Memorisation OK
Cancellation OK
Status
All OK
All OK
The device recognition phase has
not been carried out, or there are
errors in the data saved
Devices recognition phase in pro-
gress
Status
All OK
All OK
There is no memorised opening
angle
Opening angles auto-recognition
phase in progress
A
M M M M FLASH
Action
No memorisation in progress
During memorisation in mode 1, it is normal for it to take a maximum of 10 s
During memorisation in mode 2, it is normal for it to take a maximum of 10 s
Completion of deletion of a transmitter
A command has been received from an unmemorised transmitter
Memorisation completed successfully
Completion of deletion of all transmitters
Action
"Slow" speed selected
"Fast" speed selected
It is possible that there are faulty devices. Check and if necessary repeat
the device recognition phase (see paragraph 10.3.3 "Recognition of other
devices")
Indicates that it is in the process of recognising the attached devices (this will
take a maximum of a few seconds)
Action
Cycle operation
Complete cycle operation
Carry out the recognition phase (see chapter "3.5.2 - Leaf open and closure
angles recognition").
Indicates that the open angles self-learning phase is in progress
B C
BUS STOP SbS
D
E
F