Sensor Assignment With The Hand-Held Transmitter - Becker CentronicPLUS Notice De Montage Et D'utilisation

3s

Sensor assignment with the hand-held transmitter

3s
24 - en
Then press the programming button on the transmitter for 3 seconds to
change to normal mode.
► The indicator lamp goes out.
Bring the transmitter as close as possible to the required sensor.
Press the programming button on the transmitter for 3 seconds. The
transmitter performs a search and the LED ring continuously changes
colour. The transmitter then switches to receiver selection and selects
the sensor/receiver with the best connection quality.
▻ The sensor/receiver confirms.
If you do not receive confirmation from the required sensor, you can
press the / button to toggle between the available sensors/receivers
until the indicator lamp on the required sensor flashes 3 times to
confirm.
▻ The transmitter displays the current assignment status via the
LED ring.
Assignment status
Lights up yel-
low:
Lights up blue:
Lights up green: The receiver is assigned to the se-
Lights up white: Centronic PLUS sensor selected.
Lights up red:
The sensor/receiver is not yet part
of the installation or is in the as-de-
livered condition.
Briefly pressing the STOP but-
ton adds the device to the install-
ation and updates the assignment
status.
The receiver is not assigned to the
selected channel.
lected channel.
No receiver located.