Intended Use - Becker CentronicPLUS Notice De Montage Et D'utilisation

• When connecting the control cables (protected extra-
low voltages), only use cables with sufficient electrical
strength.
• Observe the specifications for the sun protection sys-
tem.
The sensor described in these instructions must only be used for CentronicPlus-com-
patible radio drives and radio control units.
• Please note that radio-controlled systems may not be used in areas with a high risk
of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and systems in which
malfunctions in the transmitter or receiver would not pose any risk to persons, an-
imals or property, or which contain safety devices to eliminate such risks.
• The operator is not protected from interference from other telecommunications
systems and terminal equipment (e.g. even from radio-controlled systems which
are properly operated in the same frequency range).
• Only connect radio receivers to devices and systems approved by the manufac-
turer.
• Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
• Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

19 - en