Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- refit the drip tray then secure it with the screws; fit the plastic
plugs (supplied) in the holes left vacant by the water line con-
nections.
(All trays are prearranged for condensate drainage on either
side.
Before connecting up the condensate drain, use a tool to
open the diaphragm in the tray (where fitted) on the water
connection side. Seal the unused drain outlet using the
plug provided.
- Remove the electrical connections from the right hand side.
Remove the push-out and move the cable sheath from the
right to the left.
- Move the motor cable to the left hand side, passing it throu-
gh the protective sheath.
- Move the terminal board and the earthing pin to the left
hand side.
- Restore the motor cable electrical connections.
- Disconnect the microswitch.
- Remove the reinforcing stay.
- Pass the wire for the microswitch through the opening on
the opposite side.
- Secure the reinforcing stay.
8
Use H05V-K or N07V-K cables with insulation 300/500 V in con-
duit or raceway. All cables exterior to the fancoil must be pro-
tected in this way.
Only use power cables with a minimum cross section of 1.5mm
Position cable lengths not protected by the conduit or race-
way in such a way as to ensure that they are not subject to
stress, twisting or external agents.
When making connections, always refer to the wiring dia-
grams supplied with the unit and shown in this document.
To protect fan coils against short circuits, always fit the
power cable to the units with 2A 250V (IG) thermo-magne-
tic all-pole switches with a minimum contact gap of 3 mm.
Each control panel controls a single fancoil.
COIL ROTATION
If coil rotation is required when making water connections,
remove the unit housing then proceed as follows:
- disconnect wires from the terminal block;
- remove the screws securing the drip tray, then lift it out;
- remove the screws securing the coil, then lift it out;
- remove the push-outs on the right side;
- rotate the coil, then secure it in place with the screws pre-
viously removed;
2
N
L
Publicité
Table des Matières
