Leggett & Platt performance Queen Manuel Du Propriétaire page 21

REMOTE CONTROL PROGRAMMING (separating 2 bases)
Separate Two Bases - for independent adjustable base
movement,
perform the following numbered procedure.
STEP 1
Locate the control box for base 1, attached to the
underside of the base (FIGURE 16). The control box
will be mounted in a housing.
FIGURE 16
CONTROL BOX
STEP 2
On the control box, press the learn button four times
in rapid succession until the green LED stays on
(FIGURE 16).
Within three seconds, press the learn button one
more time to confirm success (green LED will go off).
STEP 3
Repeat procedure for base 2.
STEP 4
Unplug both adjustable bases form the electrical
power source. Wait 30 seconds, then plug the cord
for base 1 back into the power source.
STEP 5
Locate the control box for base 1, attached to the
underside of the base (FIGURE 16).
STEP 6
On the control box, press the learn button two times
in short succession. A green LED will illuminate and
stay on (FIGURE 16).
GREEN LED
LEARN
BUTTON
REMOTE CONTROL 1
REMOTE CONTROL 2
STEP 7
On remote control 1, simultaneously press and hold
the HEAD UP and FLAT buttons (FIGURE 17). The
green LED on the control box will shut off.
STEP 8
Plug the electrical cord for base 2 back into the
power source.
Repeat Steps 5 thru 7 with base 2 and remote
control 2.
Independent remote control operation is now
restored (remote control 1 operating base 1; remote
control 2 operating base 2).
HEAD UP
BUTTON
FIGURE 17
Performance Models Signature Owners Manual 99301468-b
BASE 1
BASE 2
FLAT
BUTTON
21