Leggett & Platt 0061/10061 Instructions De Montage

Step 1: Tap PLASTIC INSERTS into LEGS of bed frame. With flat surface up, screw WING NUTS onto GLIDES.
Figure 1
Thread GLIDES into the PLASTIC INSERTS. See Figure 1.
Step 2: Turn CENTER SUPPORT over with legs facing up. Attach CENTER CROSS ARM by inserting RIVET "A"
into NOTCH "A" then pivot so RIVET "B" locks into NOTCH "B" as shown in Figure 2. Repeat with both CENTER
CROSS ARMS.
Step 3: Attach SIDE RAILS to headboard and footboard. If installing hook-on
rails, make sure that hook-on brackets grip the post pins. If installing bolt-on
LEG
rails, make sure that all nuts and bolts are securely tightened. Swing CROSS
PLASTIC
ARMS out 90 degrees. Loosely thread L-SCREWS into CLAMPS and slide
INSERT
onto CROSS ARMS as shown in Figure 3. Place assembled CENTER
WING
SUPPORT in the center of the bed.
NUT
Step 4: Slide CLAMPS onto overlapped CROSS ARMS. Position CLAMPS
GLIDE
one inch from edge of LOWER CROSS ARMS as shown in Figure 4. Tighten
all L-SCREWS.
Figure 3
CLAMP
CENTER
CROSS ARM
CLAMP
90
CROSS
ARM
CENTER
SUPPORT
0061/10061 ASSEMBLY INSTRUCTIONS
Step 5: Adjust height of GLIDES so that they touch the
floor. Lock GLIDES in place by turning WING NUTS tight
against PLASTIC INSERTS. Note: There must be at least
one inch of the glide stem in the plastic insert.
WARNING for hook-on rails: After adjusting glide
height, make sure hooks are securely gripping post
pins.
CROSS
ARM
(Model 10061 shown.)
SIDE RAIL
Figure 2
RIVET "B"
RIVET "A"
NOTCH "A"
NOTCH "B"
CENTER
SUPPORT
Figure 4
CLAMP
1"
DATE 99300436
DWG. NO.
5-18-06
DO NOT SCALE DRAWING
CENTER
CROSS ARM
LOWER
CROSS ARM
L-SCREW
SHEET 1 OF 2