Leggett & Platt performance Queen Manuel Du Propriétaire page 9

STEP 5
Plug electrical feed cord (factory attached to base) into power brick
(FIGURE 3). Plug one end of electrical power cord into power brick
(FIGURE 4) and the other end into a working, grounded electrical outlet.
Note: An electrical surge protection device is recommended (not included).
FIGURE 3
POWER
BRICK
FIGURE 4
POWER
BRICK
INSTALLATION
ELECTRICAL
FEED CORD
(factory attached
to base)
ELECTRICAL
POWER CORD
Performance Models Signature Owners Manual 99301468-b
9