Leggett & Platt performance Queen Manuel Du Propriétaire page 14

d. Using (2) 3 inch long carriage bolts/nuts, attach (1) headboard
bracket channel to (1) channel connector (FIGURE 10). Hand
tighten bolts/nuts (loosely) to allow adjustment of the headboard
bracket channels.
USE (2) 3 INCH LONG CARRIAGE
FIGURE 10
BOLTS TO ATTACH HEADBOARD
BRACKET CHANNEL TO BASE FRAME
e. Attach (1) headboard bracket flange to one of the bracket channels with
(2) 1 inch long hex head bolts/nuts (FIGURE 11). Tighten bolts.
f. Repeat procedure to attach the other headboard bracket.
FIGURE 11
USE (2) 1 INCH LONG HEX
HEAD BOLTS TO ATTACH
HEADBOARD BRACKET
FLANGE TO BRACKET
CHANNEL
14
Performance Models Signature Owners Manual 99301468-b
INSTALLATION
SLIDE BRACKET
ASSEMBLIES IN OR
OUT TO ACHIEVE
POSITION
ADJUST AS
REQUIRED TO
ACHIEVE POSITION
HEADBOARD
BRACKET
CHANNEL
(queen size
shown)
HEADBOARD
BRACKET
FLANGE