Leggett & Platt performance Queen Manuel Du Propriétaire page 20

REMOTE CONTROL PROGRAMMING (1 remote control - 2 bases)
Program One Remote to Operate Two Bases - perform the following
numbered procedure. Note: Only one remote needed. Remove batteries
from second remote and store in a safe place for future use.
STEP 1
Unplug both adjustable bases from the electrical
power source. Wait 30 seconds, then plug the cord
for base 1 back into the power source.
STEP 2
Locate the control box for base 1, attached to the
underside of the base (FIGURE 16). The control box
will be mounted in a housing.
FIGURE 16
CONTROL BOX
STEP 3
On the control box, press the learn button two times
in short succession. A green LED will illuminate and
stay on (FIGURE 16).
STEP 4
On the remote control, simultaneously press and
hold the HEAD UP and FLAT buttons (FIGURE 17).
The green LED on the control box will shut off.
STEP 5
Plug the cord for base 2 back into the power source.
STEP 6
Locate the control box for base 2, attached to the
underside of the base (FIGURE 16). The control box
will be mounted in a housing.
STEP 7
On the control box, press the learn button two times
in short succession. A green LED will illuminate and
stay on (FIGURE 16).
20
Performance Models Signature Owners Manual 99301468-b
GREEN LED
LEARN
BUTTON
STEP 8
On the remote control, simultaneously press and
hold the FOOT UP and FLAT buttons (FIGURE 17).
The green LED on the control box will shut off.
One remote control is now programmed to operate
two bases.
HEAD UP
BUTTON
FIGURE 17
BASE 1
BASE 2
FOOT UP
BUTTON
FLAT
BUTTON