Leggett & Platt performance Queen Manuel Du Propriétaire page 11

STEP 9
Install mattress retainer at the foot end of the adjustable base as follows:
a. Locate grommeted holes at foot end of base.
b. Place mattress retainer ends into grommeted holes in top surface
of adjustable base (FIGURE 6). Press down until horizontal retainer
section is flush against base.
FIGURE 6
NOTE: If base is to be set up without a headboard, install
mattress to complete basic installation. If headboard
is to be installed, proceed to Headboard Bracket
Installation. (Headboard Bracket sold as accessory.)
INSTALLATION
MATTRESS
RETAINER
Performance Models Signature Owners Manual 99301468-b
11