Leggett & Platt performance Queen Manuel Du Propriétaire page 10

STEP 6
Remove the plastic packaging from the base frame. Carefully
rotate the adjustable base over to position the base so it is
resting on its legs.
STEP 7
Install batteries in remote control (3-AAA, included) (FIGURE 5). Note:
Make sure to orient batteries properly. Briefly activate all functions of the
base with the remote control to verify all features are in working order. If
base does not operate, refer to the Troubleshooting section of this manual.
FIGURE 5
TABS
BATTERY
COMPARTMENT
DOOR
PRESS IN ON TAB AND LIFT OUT TO
REMOVE BATTERY COMPARTMENT
DOOR. INSERT TABS IN TAB SLOTS
AND SNAP IN TO REPLACE.
STEP 8
Return base to the level position.
10
Performance Models Signature Owners Manual 99301468-b
INSTALLATION
NEGATIVE (-)
END
POSITIVE (+)
END
BOTTOM
OF REMOTE
CONTROL