Input Setup - Grundfos DME 2 Notice D'installation Et D'entretien

Operating display
Fig. 20 Selection of language

4.20 Input setup

Fig. 21 shows all possible settings.
The level and stop inputs can be changed from NO
(normally open) to NC (normally closed) function.
If changed, the inputs must be short-circuited in
normal operation.
Fig. 21 Input settings
20
Operating display
For the analog input, one of the following signal
types can be selected:
• 4-20 mA (default),
• 20-4 mA,
• 0-20 mA,
• 20-0 mA.
See also section 4.11 Analog.
Change the level input to an input for dosing monitor-
ing as illustrated in fig. 21.
Use the buttons
for navigation
Operating display
without changes