Chamberlain GAROG DK Serie Manuel D'instructions page 42

OPERATING INSTRUCTIONS
The door control AS2-eco is conceived to operate door units with three-phase
motors in dead-man operation mode.
For example, a triple switch is connected with to open or close a gate.
SAFETY INSTRUCTIONS
Please consider valid national and local directives and regulations related
to the start-up of motorised doors in your country. The person and/or the
company installing the unit is responsible of the complete unit. The
installator has to respect the important norms and directives ( such as
DIN EN 12453, DIN EN 13241-1) and establish the technical documents
related to the whole unit. The technical documents have to be enclosed to
the door's unit.
Installation and maintenance works at the control AS2-eco have only to be
done by specialised technicians in electrics.
During works on electrical devices, the unit must be switched off supply.
All regulations related to protection must be considered.
Dead-man operation mode is only allowed if the unit is visible from the
instruction switches and the operators were instructed correspondingly.
The operation of the gate control in self-locking mode is only allowed if
the protecting equipment required in EN 13241-1 und EN 12453 are used.
If you do not respect the safety instructions, you are personally liable f
the resulting damages on persons and materials.
12
AS2-eco
or
Revision_11_2007