Electrical Connection - Chamberlain GAROG DK Serie Manuel D'instructions

Motorisation pour portes industrielles

Masquer les pouces

Table des Matières

Les langues disponibles

Before the installation of power cables and control devices it is essential to take note of all the

following specifications and warnings. If they are not heeded serious injuries or damage to the

drive can occur.

The control housing of the door drive may only be opened by trained"Chamberlain" specialist

personnel. If necessary please contact your local Chamberlain dealer.

Before electrical installation or the starting up of the drive please study the circuit diagram

carefully. The valid local regulations must be followed for all the electrical wiring work.

Before carrying out any maintenance work on the door drive it is first necessary to disconnect

the power supply / power transmission at the main switch.

After completion of the maintenance work the danger zone must be cleared and secured again

before restarting.

If you require additional accessories or spare parts

MATRIX FOR THE USE OF SAFETY EQUIPMENT

TYPE OF CONTROL

Control by continuous switch

operation

Pulse actuation within visual

range of door

Automatic control

Pushbutton for control by holding down continuously

Keyswitch, or suchlike for controlling by means of continuous actuation

Limitation of driving force by force limiting (clutch) and protection devices

(safety edge padding).

Device to detect people or obstacles which are on the ground on one side (inside) of the door

leaf (infrared light barrier)

Device to detect people or obstacles which are on the ground on both sides

(inside and outside) of the door leaf (infrared light barrier).

ADVICE: For more detailed information see EN12453.