Important Notes; Symbols Used; Liability And Warranty; Safety - Schwamborn DSM 250S Traduction Du Manuel D'utilisation Original

EN DSM 250S floor grinding machine

1 Important notes

1 Important notes
The machine may be used only with the accessories
supplied by the manufacturer for stripping, wet and
dry grinding of floor surfaces such as:
— cement
— screeds
— synthetic resin screeds / asphalt
— natural stone floors
— residual adhesive or filling compound
— floor remnants (e.g. foam backing)
Any other use of the machine can lead to dangerous
situations and is prohibited!
To ensure correct use of the machine, follow the
instructions in the operating instructions, paying
particular attention to any warnings and instructions
relating to operation and maintenance!
Before using the machine, the
operating personnel must carefully
read and understand these operating
instructions!
Keep these operating instructions
close at hand for easy reference!
Read and observe documents and operating
instructions provided by suppliers!
If the machine is on loan to other parties, the
operating instructions needs to be provided with the
machine and its importance must be made clear!

1.1 Symbols used

The following symbols are used in this
documentation:
Safety instructions
This symbol indicates warnings, prohibitions and
instructions regarding potential hazards. These
instructions must be obeyed and closely
observed.
Some safety instructions are accompanied by
corresponding symbols.
Warning
Additional information
This symbol indicates additional information.
14
Prohibition Direction

1.2 Liability and warranty

 Schwamborn Gerätebau GmbH
All rights, including those pertaining to translation, lie
with Schwamborn Gerätebau GmbH.
No part of this documentation may be reproduced,
used or distributed in any form without the written
permission of Schwamborn Gerätebau GmbH.
Liability or warranty is excluded if:
— The instructions in the operating manual
have not been observed.
— The machine or its attachments were im­
properly operated.
— The maintenance was carried out inade­
quately or incorrectly.
— Specified spare parts were not used.
— The protective equipment was not used,
has been altered or was removed.
— The specified power supply ratings and
surrounding conditions have not been ob­
served.
— Unsuitable tools have been used.
— An unsuitable dust extraction has been
used.
The manufacturer is not liable for damage caused by
changes to the machine that were made without the
manufacturer's permission. Any such actions will void
the warranty.

2 Safety

This chapter contains a summary of the most impor­
tant information on safety when handling the
machine.

2.1 Accident prevention and safety

The following instructions comply with legislation, di­
rectives and publications such as:
— EU Machinery Directive
— EU Product Liability Directive
— Law governing technical materials
— Law governing equipment safety
— Law governing product liability