Programming Or Changing The User Code; Deleting The User Code; Determine „Lock Out" Relay Switching Duration - Renkforce 751905 Notice D'emploi

7.3 Programming or changing the user code

There are two ways of entering or changing a user code:
Option 1:
Input example:
*
MMMM MMMM
Second option:
Input example:
*
MMMM MMMM
Important!
When choosing your master and user code, please ensure that they have the same number of
character.
When you have programmed a master code with 6 characters in chapter 7.2, you also have to
program all user codes with 6 characters exactly.
If the character length of the master code is changed (e.g. if you programme a new master code
with 4 characters), you need to re-programme the user codes as well (also with 4 characters).

7.3.1 Deleting the user code

To delete one or all user codes, proceed as follows:
Input example:
*
MMMM MMMM
7.4 Determine „Lock Out" relay switching duration
You can define the switching duration of the „Lock Out" (10) relay contacts.
The default setting for the switching duration is 5 seconds.
Proceed as follows:
Input example:
*
MMMM MMMM
XX code #
6YY code #
50 XX #
20 TT #
Explanation
XX = storage position number 01-19
code = new user code (4-8 characters)
Explanation
XX = storage position number 20-99
code = new user code (4-8 characters)
Explanation
XX = storage position number 01-99
XX = To delete all user codes, enter "00" instead of the
storage position number.
Explanation
TT = 01-99 seconds
TT = 00 Activation until user code input
21