KTM Power Parts 61412927033 Mode D'emploi page 5

Scope of supply
1x base support
1x back plate
2x countersunk screw M6x50
2x countersunk screw M6x30
4x assembly kit
4x countersunk screw M6x30
4x rubber mount
4x spacer
8x rubber washer
4x sliding guide
4x sliding bushing
4x nut
Preparatory work
- Take off the passenger seat (see the Owner's Manual).
Assembly
- Remove screws .
- Remove suitcase brackets on both sides.
- Remove the side cover on both sides.
In order to avoid damaging the side covers, fi rst pull the catch
from the bracket in area
- Remove screws with seat support rubber sleeves.
- Remove screws .
- Remove passenger seat handle.
- Position base support (included).
- Mount screws , but do not tighten them yet.
- Mount screws with seat support rubber sleeves and tighten to 18 Nm.
- Mount screws and tighten to 18 Nm.
- Position rubber mounts, spacers, rubber washer and sliding guides
(see fi gure, right) of assembly kit
and then slip out from area
(included).
.
5