Intended Use; Scope Of Delivery; Device Description - Kulzer signum HiLite pre 2 Mode D'emploi

In addition to the instructions in this operating manual, comply with the national laws, regulations,
and directives in your country when setting up and operating the machine.
Only permissible original spare parts / accessory parts must be used.
The use of different parts holds unknown risks and must be avoided at any rate.
Kulzer GmbH will not accept any liability for damage to the unit resulting from inexpert repair which has not been
performed by Kulzer service agents or if no original spare parts / accessory parts have been used during the exchange
of these parts.
3

Intended use

The device HiLite pre 2 is designed to be used for prepolymerisation of light-curing composite materials in dental
laboratories.
CAUTION
Do not use the device for any of the activities described below:
– Do not use the device to heat or prepare food.
– Do not treat or use easily combustible materials, liquids or gases.
– Do not use on patients.
4

Scope of delivery

Check that all components are in perfect condition on delivery of the machine.
If you wish to make a complaint, contact your supplier.
Delivery unit:
– 1 x Hand piece (incl. lithium ion battery) with Working Instructions.
– 1 x Power supply with international plug set, glare shield, clip, Support-Pod.
5

Device description

1 ON and OFF switch /
charging contact
2 Hand piece
3 Clip
Support-Pod
4
5 Lens barrel (Speed Focus)
6 Glare shield
7 Charging unit with USB-Port
Magnetic charging clip with
8
charging indication light
1
2
3
4
8
GB
- 3 -
5
6
7