Table des Matières
Publicité
c.
To remove any remaining residue, wipe cleaned surfaces again with a clean, damp lint-
free cloth.
d. Repeat steps a, b and c for all surface.
Turn the table's power off with Hand Pendant when finished with cleaning procedure.
5.
6.2.2
End-of-Day Cleaning Procedures
1.
Perform cleaning procedures as described in Section 6.2.1.
2.
Clean floor lock pads:
a. UNLOCK table floor locks.
b. Wipe floor lock pad with a cloth, dampened with water, to remove cleaning fluid and
debris.
Figure 6-1: Auto Floor Lock
6.2.3
Weekly Cleaning Procedures
1.
Perform Section 6.2.1 and 6.2.2 cleaning procedure.
2.
Go through all movements of table and clean all additional surfaces exposed during
these articulations as follows:
a. Hold the can of spray six to eight inches from surface and spray.
b. Use a clean piece of lint-free cloth to wipe sprayed surfaces, dampened with water to
remove cleaning fluid. To minimize streaking use a damp cloth.
c. To remove any remaining residue, wipe cleaned surfaces again with a clean, damp, lint-
free cloth.
Figure 6-2: Manual Floor Lock
6-4
B2AV800 Series Surgical Table
IM-B2AV800-E01
Publicité
Table des Matières
