Arm Board - Nuvo B2AV800-1 Manuel

Many accessories are attached to the table's side rails; these accessories need side rail locks
or Clark sockets to help secure them in place.
To install a side rail lock (figure 5-10), place it on the side rail, then insert the rectangular rod of
accessory through the corresponding rectangular hole, and lock the accessory into position with
thumbscrew. To uninstall, reverse the steps of installation.
To install a Safety Clark socket (figure 5.11), slide it in from either end of the side rail or else
simply place it on the side rail. Secure the socket first before placing the round rod of
accessory through the Clark socket's corresponding round hole, and lock the accessory into
position with screw. To uninstall, reverse the steps of installation.
Figure 5-10:

5.3.3 Arm Board


When using a third party arm board, keep an angle greater than 15 degrees along the
direction of table length to avoid component damage during tabletop movements.
Lorsque vous utilisez un support de bras fourni par un autre fabricant, gardez un angle
supérieur à 15 degrés dans le sens de la longueur de la table pour éviter d'endommager
les composants lorsque vous articulez la table.
Figure 5-11:
CAUTION! MISE EN GARDE!
5-24
B2AV800 Series Surgical Table
IM-B2AV800-E01