Table des Matières
Publicité
d. Repeat steps a, b and c for all surface.
Turn the table's power off with Hand Pendant when finished with cleaning procedure.
5.
6.2.2
End-of-Day Cleaning Procedures
1.
Perform cleaning procedures as described in Section 6.2.1.
2.
Clean floor lock pads:
a. UNLOCK table floor locks.
b. Wipe floor lock pad with a cloth, dampened with water, to remove cleaning fluid and
debris.
Figure 6-1:
6.2.3
Weekly Cleaning Procedures
1.
Perform Section 6.2.1 and 6.2.2 cleaning procedure.
2.
Go through all movements of table and clean all additional surfaces exposed during
these articulations as follows:
a. Hold the can of spray six to eight inches from surface and spray.
b. Use a clean piece of lint-free cloth to wipe sprayed surfaces, dampened with water to
remove cleaning fluid. To minimize streaking use a damp cloth.
c. To remove any remaining residue, wipe cleaned surfaces again with a clean, damp lint-
free cloth.
Turn the table's power off with Hand Pendant when finished with cleaning procedure.
3.
6-4
B2AV1000 Series Surgical Table
IM-B2AV1000-E01
Publicité
Table des Matières
