After A Clean Cycle; Timer - Monogram ZDP486NRPSS Manuel Du Propriétaire

After a clean
cycle

Timer

49-85247
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven cools.
If white spots remain, remove them with
warm sudsy water and rinse thoroughly with a
vinegar and water mixture. These deposits are
usually a salt residue that cannot be removed
by the clean cycle.
NOTE: The timer is independent of all the
other functions and does not control the oven.
To set the timer:
1. Push the TIMER button.
2. Turn the Mini-Knob to adjust any length of
time up to 12 hours and push to select it.
On double oven models, each oven control
has its own timer function. Each timer can be
set independently.
The control will beep with 1 minute remaining
and the display will show seconds until the
timer counts down to :00. When the timer
reaches :00, the control will beep 3 times
followed by one beep every 6 seconds until
the Mini-Knob is pushed.
To cancel the timer:
1. Push the TIMER button.
2. Turn the Mini-Knob to :00 and push to select.
To adjust the timer after start:
1. Push the TIMER button.
2. Turn the Mini-Knob to a new desired time
and push to select.
Self-Cleaning Oven
Professional Dual Fuel Range
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE: The timer cannot be used while
the oven is self-cleaning. (On double oven
models, the timer for the oven that is not in the
self-cleaning mode may be used.)
Mini-Knob
Turn to adjust
Push to select
27