Oven racks
30
The racks may remain in the oven during the
self-cleaning cycle without being damaged.
Periodically, after several self-clean cycles,
the oven racks may need to be lubricated
using the Graphite Lubrication shipped with
your range. To order additional Graphite
Lubrication, call our National Parts Center at
800.626.2002 and reference WB02T10303.
1. Remove rack from the oven. See the Full
extension oven racks section.
2. Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3. If there is debris in the slide tracks, wipe
it away using a paper towel. NOTE: Any
graphite lubricant wiped away must be
replaced.
4. Shake the graphite lubricant before opening
it. Starting with left slide mechanism of the
rack, place four (4) small drops of lubricant
on the two (2) bottom tracks of the slide
close to the bearing carriers.
Care and Cleaning
Professional Dual Fuel Range
Right side
5. Repeat for the right slide mechanism of the
rack.
Left side
Rack right-side-up
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and shake
it again. Turn the rack over and repeat
steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up and
place in the oven. See the Full extension
oven racks section.
9. Repeat above steps for each rack.
NOTE: Do not use a cooking spray or other
lubricant sprays on the slides.
Rack right-
side-up
49-85247