Multiplex PARTENAVIA P.68 Instructions De Montage page 20

Control Horns Installation
Make sure all servos are in their central position and adjust the linkages
to the indicated positions.
Hole reference for flap servo linkage
EN
Hole reference for aileron flap servo linkage
�
Battery Installation
1. Before connecting the battery to the plane, power on the transmitter
and ensure throttle lever in the lowest position.
2. Remove the battery hatch.
3. Insert battery into the battery compartment with the power cable
towards the rear of the plane and use straps to secure the battery.
4. If necessary reposition battery to adjust the center of gravity (CG) by
moving the battery forward or backward.
CG Setting
Correct center of gravity is very essential for a successful flight.
Please refer to the below diagram to adjust the CG of the plane.
20
The following pictures show the default factory settings for the control
horns and linkages recommended for use for initial flight.
Hole reference for elevator servo linkage
�
Hole reference for rudder servo linkage
�
- Adjust the CG position by moving the battery forwards or backwards. If
necessary add ballast weight to achieve the correct CG position before flight.
53-58mm
�
�