User Manual Speed Controller - Multiplex PARTENAVIA P.68 Instructions De Montage

User Manual of Brushless Speed Controller
Thanks for purchasing our Electronic Speed Controller (ESC). High power
system for RC model is very dangerous, please read this manual carefully.
In that we have no control over the correct use, installation, application, or
maintenance of our products, no liability shall be assumed nor accepted
for any damages, losses or costs resulting from the use of the product.
Programmable Items (The option written in bold font is the default setting)
EN
Brake Setting Enabled / Disabled
1.
Battery Type Lipo / NiMH
2.
3. Low Voltage Protection Mode(Cut-Off Mode) Soft Cut-Off
(Gradually reduce the output power) /Cut-Off (Immediately stop
the output power)
4. Low Voltage Protection Threshold (Cut-Off Threshold) Low / Medium / High
1) For lithium battery, the battery cell number is calculated
automatically. Low / medium / high cutoff voltage for each cell is:
2.85V/3.15V/3.3V. For example: For a 3S Lipo, when "Medium"
cutoff threshold is set, the cut-off voltage will be: 3.15*3=9.45V
2) For NiMH battery, low / medium / high cutoff voltages are
0%/50%/65% of the startup voltage (i.e. the initial voltage of battery
pack), and 0% means the low voltage cut-off function is disabled.
For example: For a 6 cells NiMH battery, fully charged voltage is
1.44*6=8.64V, when "Medium" cut-off threshold is set, the cut-off
voltage will be: 8.64*50%=4.32V
Begin To Use Your New ESC
IMPORTANT! ecause different transmitter has different throttle range,
please calibrate throttle range before flying.
Switch on the
transmitter move
throttle stick to the top
position
Normal startup procedure
Move throttle stick to
bottom position and then
switch on transmitter
Protection Function
1. Start up failure protection: If the motor fails to start within 2 seconds
of throttle application, the ESC will cut-off the output power. In this
case, the throttle stick MUST be moved to the bottom again to
restart the motor. (Such a situation happens in the following cases:
The connection between ESC and motor is not reliable, the propeller
or the motor is blocked, the gearbox is damaged, etc.)
24
The "Beep-Beep-" tone
Connect battery pack
should be emitted, means
to the ESC, and wait
the top point of throttle
for about 2 seconds
range has been confirmed
Connect battery pack to ESC,
special tone like " 123"
means power supply is OK
Any claims arising from the operating, failure or malfunctioning etc. will
be denied. We assume no liability for personal injury, property damage or
consequential damages resulting from our product or our workmanship.
As far as is legally permitted, the obligation to compensation is limited to
the invoice amount of the affected product.
Startup Mode Normal /Soft /Super-Soft (300ms / 1.5s / 3s)
5.
a) Normal mode is suitable for fixed-wing aircraft. Soft or Super-
soft modes are suitable for helicopters. The initial acceleration of
the Soft and Super-Soft modes are slower, it takes 1.5 second for
Soft startup or 3 seconds for Super-Soft startup from initial throttle
advance to full throttle. If the throttle is completely closed (throttle
stick moved to bottom position) and opened again (throttle stick
moved to top position) within 3 seconds after the first startup, the
re-startup will be temporarily changed to normal mode to get rid of
the chance of a crash caused by slow throttle response. This special
design is suitable for aerobatic flight when quick throttle response
is needed.
6. Timing Low
Usually, low timing is suitable for most motors. To get higher speed,
High timing value can be chosen.
Throttle range setting (Throttle range should be reset whenever a
new transmitter is being used)
Move throttle stick to the
bottom position, several
"beep-" tones should be
emitted to present the
amount of battery cells
Several "beep-" tones
When self-test is finished,
should be emitted to
a long "beep-----" tone
present the amount of
should be emitted
lithium battery cells
2. Over-heat protection: When the temperature of the ESC is over about
110 Celsius degrees, the ESC will reduce the output power.
3. Throttle signal loss protection: The ESC will reduce the output power
if throttle signal is lost for 1 second, further loss for 2 seconds will
cause the output to be cut-off completely.
/ Medium / High,( 3.75°/15°/26.25°)
A long "Beep-" tone should
be emitted, means the
lowest point of throttle range
has been correctly confirmed
Move throttle stick
upwards to go flying