Use - Cooke & Lewis CLFDT60 Mode D'emploi

Use

Utilizare
Before you start
A
• Switch on the appliance at the switched fused connection unit. The appliance is ready for use.
WARNING: Read the instructions before using the appliance.
• To avoid the risks that are always present when you use an electrical appliance it is important that this appliance is installed
correctly and that you read the safety instructions carefully to avoid misuse and hazards.
• Please keep this instruction booklet for future reference and pass it on to any future owners. After unpacking the appliance
please check that it is not damaged. If in doubt, do not use the appliance but contact the customer service helpline.
• Check the package and make sure you have all of the parts listed.
• Decide on the appropriate location for your product.
• This product contains glass, please take care when fitting or handling to prevent personal injury or damage to the product.
• If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so
that the new owner can become familiar with the appliance and its safety warnings.
• Note! Before using the oven for the first time we recommend that the oven is switched on and set to its highest temperature.
Keep the oven door closed and leave the appliance on for 1.5 hours with nothing in it.
• Ensure adequate ventilation during this process by opening doors and windows in the room. Any odours created during this
operation are due to the evaporation of substances used to protect the appliance during storage prior to installation.
Function & Settings
A
01
Setting the clock
• Once the appliance is connected to the power source, the display shows 12:00 and the
right time. The clock is now available for setting in 24-hour format.
• To set the right time, press "–" or "+" to adjust. There is a 5-second lapse for acceptance during which no button must be
touched. The rate of change will increase considerably a few seconds after the buttons have been depressed.
• To change the clock time, we can press "F"4 times until the
WARNING: any power cut cancels the programmed functions, including the clock.
When the power supply returns, the
02
Using the oven
The oven is controlled by a thermostat (8)between 50 ºC and 250 ºC, depending on the temperature required. The temperature
indicator(7) turns on and off to indicate the temperature control during use. The required cooking mode is selected using the multi-
functional control button(9). The functions that may be selected are:
Icon Function
Oven light
Defrosting
Convection with fan The upper and bottom heating elements are both switched on, accompanied by the fan. An even
Grill
Bottom heating
Utilisation
Uso
Description
The oven light will illuminate in the oven cavity. All other cooking modes are disabled. Note: The oven
light also illuminates during all operation modes.
Only the fan comes on and the food is thawed by ventilation without heat.
temperature is produced on all shelves within the oven. It is recommended that the oven is preheated
for 10-15 minutes before commencing cooking.
Only the top heating element switches on. Heat is distributed by natural convection and this means
that the top half of the oven is warmer than the bottom half. Food should be placed on a higher shelf
if the food is to be crisped. It is recommended that the oven is preheated for 10-15 minutes before
commencing cooking.
Only the bottom heating element switches on. This provides more direct heat to the base of food without
browning. It is recommended that the oven is preheated for 10-15 minutes before commencing cooking.
Użytkowanie
indicator flashes and set the correct time with "–" and "+".
indicator will flash and can be reprogrammed.
indicator will flash until we enter the
11