Changing Colour Strips Of The Sensor Unit; Appendix; Technical Data; Troubleshooting - hager WXH20 Serie Mode D'emploi Et Instructions De Montage

e

5.4 Changing colour strips of the sensor unit

The sensor unit can be adapted to match the colour of the wall using the col-
our strips supplied.
Remove sensor unit carefully from the mounting bracket (8).
„
Remove front cover (6) by lifting at the back of the sensor unit.
„
Attach the desired colour strips to the sensor unit.
„
When attaching the colour strips to the sensor unit, make sure that no
sensor is covered.
Fasten transparent front cover to the sensor unit.
„
Press sensor unit onto the mounting bracket (8).
„

6 Appendix

6.1 Technical data

Sensor unit
Battery type
Recommended battery type
Battery service life
Sound pressure at a distance of 1 m
Radio frequency
Range
Dimensions (W x H x D)
Degree of contamination
Power control unit
Rated voltage, 3phase
Rated current, 3phase
Conductor cross-section, 3phase
Rated voltage, 1phase
Rated current, 1phase
Conductor cross-section, 1phase
Energy consumption
Degree of contamination
Rated surge voltage
Operating temperature
42
AA/LR6 Alkaline
Duracell Ultra Power (MX1500)
3 ... 5 years
70 ... 75 dB (A)
10 ... 100m, depending on building structure
125 x 17 x 45mm
5 x 2.5 mm²
+5 ... +35°C
Ball pressure test
Creep resistance (PTI)
Number of switching operations
Dimensions (L x W x H)
Degree of protection
Standard
Potential-free contacts
Rated voltage
Rated current

6.2 Troubleshooting

Power supply to the cooker is switched off.
Cause 1: Battery level of the sensor unit is too low. Battery display (7) flashes.
Replace batteries.
Cause 2: Mounting position of the sensor unit is wrong and the status LED (5)
flashes yellow (●●●).
Check mounting position of the sensor unit and adjust if necessary (Figure
6).
2.4 GHz
Cause 3: Radio connection is interrupted and status LED (5) flashes blue (●).
Establish radio connection manually in setting mode 2 (see Manual commis-
sioning).
2
Cause 4: Power control unit is overheated and status LED (5) flashes blue
(●●●).
400 V
Let the device cool down for a while. If it occurs again, contact an electri-
3 x 16 A cian.
Cause 5: Problem with the sensor unit and status LED (5) flashes yellow (●●).
230 V Check batteries or have sensor unit checked.
1 x 25 A Cause 6: Problem with the sensors and status LED (5) flashes yellow (●).
Clean sensor unit and sensors carefully.
3 x 6 mm²
4 W
2
4 kV
e
100 °C
175 ... 400
approx. 6000
239 x 113 x 42 mm
IP20
IEC/EN 60730-1: Type 1.B
DIN EN 50615
DC 3 ... 24 V
max. 10 mA
43