Accessories - hager WXH20 Serie Mode D'emploi Et Instructions De Montage

e
Power supply to the cooker is switched off and switched on again
immediately.
Cause: Power control unit is connected incorrectly.
Check that the connection of the cooker supply cable and cooker connec-
tion cable have the right terminal assignment (IN/OUT).
Water leakage alarm triggers.
Cause: The leakage sensor is not sufficiently dried or is dirty.
Dry or clean water leakage sensor.
Sensor unit does not react when button is pressed.
Cause 1: Battery charge too low.
Replace batteries.
Cause 2: Batteries are not inserted correctly.
Check that the batteries are in the correct position according to the marking
on the bottom of the battery compartment and correct the position if neces-
sary.
The fault signals that possibly occurred and their problem description are listed
in table 6.
Status LED (5) flashes blue
●
●●
●●●
Status LED (5) flashes yellow
●
●●
●●●
Table 6: Fault signal

6.3 Accessories

Water leakage sensor
KNX radio binary input 2gang flush-mounted
KNX radio binary input 2gang flush-mounted 230 V
44
Problem description
Problem with the radio connection
Problem with the power control unit
Power control unit is overheated
Problem description
Problem with the sensors
Problem with the sensor unit
Wrong mounting position of the sensor unit
TRB302A
TRB302B
„
WXH202
"
e
45