Operating And Assembly Instructions; Design And Layout Of The Device; Function - hager WXH20 Serie Mode D'emploi Et Instructions De Montage

e

2 Design and layout of the device

(6)
(7)
(8)
(1)
Figure 1: View of sensor unit
(9)
(11)
Figure 2: View of power control unit
(1) Operation button 1
(2) Operation button 2
(3) Operation button 3
(4) Sensors
(5) Status LED
26
(5)
(4)
(2)
(10)
(6) Front cover
(7) Battery status LED
(8) Mounting bracket with adhesive tape
(9) Power control unit
(10) Entry for connection cable cooker/hob
(11) Connection socket for water leakage sensor
Scope of delivery
- Power control unit
- Sensor unit with mounting bracket
(3)
- white front cover for the sensor unit
- transparent front cover for the sensor unit
- Fitting material
- Cleaning pad
- 10 Colour strips for inserting in the transparent front cover
- 2 Batteries for the sensor unit (AA/LR6)
- 2 Distribution terminals for N and PE conductor connection
-

Operating and assembly instructions

3 Function

Function notes
The cookguard is designed to draw attention to hazards as early as possible and
to respond accordingly. According to the standard EN 50615 the device is able
to distinguish between the normal use of a cooker/hob and a hazard. Neverthe-
less, during normal use of the cooker/hob attention hast to be paid to hazards as
the device cannot detect all possible situations.
The sensor unit monitors the temperature increase and use of the cooker/hob.
If a potential hazard is determined, a pre-alarm is triggered if necessary. If this
is not acknowledged by the user, the power control unit switches off the power
supply to the cooker/hob after 15 seconds.
Correct use
- Ensuring the operational safety of electric cookers/hobs
- Monitoring the cooking activities and switching off the cooker after identify-
ing the hazard
- The device is only suitable for indoor areas
- Installation of the sensor unit on the wall or under the extractor hood
- Installation of the power control unit on the wall or on the floor
e
27