Attaching Antenna Tube; Inserting Battery In Vehicle - Reely 23 44 75 Notice D'emploi

c) Attaching Antenna Tube
• Release the tied up antenna cable of the vehicle.
Straighten the cable, by holding it at the end with two
fingers and by pulling it with two fingers of the other
hand several times into the direction of the receiver (do
not any apply force, don't pull cable on the receiver!).
• First, guide the antenna cable through the mount and
then slide it through the antenna pipe until it emerges
again on the other end.
Do not fold the cable, do not shorten it!
• Put the antenna tube into the place indicated on the
picture on the right with an arrow.
• If a rubber cap is included, it belongs on the end of the
antenna tube.
d) Inserting Battery in Vehicle
Take the holding bracket off, by pulling the two clips out beforehand. Now you can insert a battery pack (not part of the
delivery, must be ordered separately).
Replace the holding bracket again and secure it with the two clips.
The rechargeable battery pack must not yet be connected to the cruise control/receiver.
35