Attaching Antenna Tube; Inserting Battery In Vehicle - Reely Sturdy Notice D'emploi

Modèle réduit de voiture pouvant être radiopiloté au moyen de la télécommande
Masquer les pouces Voir aussi pour Sturdy:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

c) Attaching Antenna Tube
• Release the tied up antenna cable of the vehicle.
Straighten the cable, by holding it at the end with two
fingers and by pulling it with two fingers of the other
hand several times into the direction of the receiver (do
not any apply force, don't pull cable on the receiver!).
• Now the antenna cable is to be pushed into the antenna
tube until it comes out at the other end again.
• Put the antenna tube into the place indicated on the pic-
ture on the right with an arrow.
Do not fold the cable, do not shorten it!
• If a rubber cap is included, it belongs on the end of the
antenna tube.
d) Inserting Battery in Vehicle
Take the holding bracket off, by pulling the clip out before. Afterwards the rechargeable battery pack
can be inserted (possibly a little tight).
Replace the holding bracket again and secure it with the clip.
The rechargeable battery pack must not yet be connected to the cruise control/receiver.
37

Publicité

Table des Matières
loading

Table des Matières