Reely 23 44 75 Notice D'emploi page 35

E Trim regulator for steering limit: It limits the steering deflection. Depending on the setting, the turning circle at full
deflection of the turning wheel (H) changes.
F Servo reverse switch for forward/reverse drive: This reverses the response of the vehicle to the movement of
the lever (K).
Correct setting: Move lever (K) in the direction of the handle = vehicle drives forwards
G Servo reverse switch for steering: The response of the vehicle to steering movements per rotating wheel (H) is
reversed.
Correct setting: Turn rotating wheel (H) towards the right in clockwise direction = vehicle drives right.
H Rotating wheel for steering: Just as with a real car, turning right means that the vehicle will make a right turn. This
behaviour can be reversed via the servo reverse switch (G).
I Telescopic antenna: It needs to be pulled out all the way before driving the vehicle, otherwise the range is only
very low. At delivery the telescopic antenna is included separately, it has to be screwed on first.
J Three LEDs for display of battery or rechargeable battery state: The fewer LEDs light up, the less energy is
available for the transmitter. If only one LED lights up (or none), exchange the inserted batteries (or rechargeable
battery) for new ones.
K Finger lever for forward/reverse drive: With this you can move the vehicle forward or reverse (throttle/break or
reverse drive).
Pulling the lever in the direction of the handle is for forward drive (if necessary set correctly with the servo reverse
switch (F)).
To break, the lever is moved into the other direction as far as it will go.
To drive reverse, the lever is to be moved in the direction of the front axle. If you applied the brakes before or drove
forward, the lever has to be left in the center position for about one second first (let go of lever, vehicle stationary, set
trim regulator (C) correctly) before the vehicle is reversing.
This is for the brake function, see chapter 9. i.
L Battery/rechargeable battery compartment: This is where you insert the batteries (or rechargeable batteries)
necessary for operation.
When inserting the batteries pay attention to the correct polarity (note sticker in the battery/rechargeable battery
compartment and the writing on the battery/rechargeable batteries).
The transmitter crystals of the remote control are located on the back, it is as easily exchangeable as
that of the vehicle (only for suitable 27MHz crystals). The transmitter crystal is labeled "TX" ("T" =
"Transmit"), the receiver crystal "RX" ("R" = "Receive").
The orientation when inserting the crystal is irrelevant.
33